Refilling the Envelope Sealant Bottle

Your mailing system displays a message telling you when your E-Z Seal® Sealing Solution is running low. When you receive this message, your system can still seal approximately 50 envelopes.

NOTE: Pitney Bowes recommends using E-Z Seal® Sealing Solution because it helps keep your moistener tank clean and improves sealing performance.

Watch a demonstration.

1. Open the supplies cover and lift out the envelope sealant bottle. The bottle is located to the far left of the tape roll.

2. Remove the cap from the bottle.
3. Add enough E-Z Seal® to bring the level up to the bottom of the throat of the bottle.
• Do not overfill the envelope sealant bottle.
• Make sure you do not spill any solution in the tape well. If the tape gets wet, it can warp and cause a stoppage.
4. Replace and tighten the cap and return the bottle to its original position.
5. Close the supplies cover.

Related Topics

Adjusting the Moistness of the Sealer

Hardware Settings

Parts of the Mailing System

Back to top